Use this form if the comment contains offensive or otherwise inappropriate content. An email message will be sent to our moderators who will take appropriate action if necessary.

Write your message to the moderator below:

(Enter the numbers exactly as they appear to the left)

Comment text appears below:
I recently purchased the W1500. In 2D it is hands down superb. Bright, clean, sharp imaging. Wonderful! However, I have consistently experienced some 'unusual' issues with 3D Blu Rays. I use a PS3 for Blu Ray playback. When I insert and begin playing a 3D disk, the projector switches to 3D and runs through a 'test' mode before the disks menu appears. This takes several seconds but is normal. The issue that arises though is that when I proceed to play the movie itself, the resulting 3D playback has some significant depth of field issues that frankly make it horrible and pretty much impossible to watch. The eye is extremely confused by what is being projected. It has nothing to do with the 'invert' option (I have tested this option several times in the projectors 3D menu) as there is some sense of correctness about the image, but it is barely watchable due to the above mentioned depth issues. The only way I have found to correct the issues is that while the actual 3D movie is playing, I must switch the projector off (which takes a minute or 2 while it cools) then switch it back on while the ACTUAL movie is paying, at which point the projector runs through it's test mode again. The resulting 3D image is now correct and perfectly watchable. I have tested with several disks and 2 separate 3D glasses (one of which is the Benq glasses that came with the projector) and the problem is consistent. I am in the process of contacting Benq to see if they have a resolve for this, but wondered if others had experienced the same problems as 3D issues are commonly reported in other reviews for this projector.
Audio General